TM 5-3810-207-20/TO 36C23-3-37-12 Section VI.  CARRIER CAB AND FENDERS 313.  General The pressed steel-constructed carrier cab is mounted on the left-front side of the carrier frame.  It is designed to accommodate only the driver.  It can be removed as a complete unit.  The front fenders are belted in place and can  be  removed,  if  necessary,  to  facilitate  overhaul  of the carrier.  The rear fenders are bolted to the side rails. A heavy-duty guard shields the front of the radiator.  A sandshield  is  bolted  to  the  right-front  fender  to  protect the battery box and hood assembly. 314.    Windshield,  Side  Triangular  Glass,  and  Rear Glass a. Removal.      The  windshield,  side  triangular glass, and rear glass are removed in the same manner as  the  door  window  and  windshield  glass  in  the  crane (par.  122). b. Installation.    The  windshield,  side  triangular glass,  and  rear  glass  are  installed  in  the  same  manner as  the  door  window  and  windshield  glass  in  the  crane (par.  122). 315.  Side Window Glass a. Removal.    Remove  the  side  window  glass as instructed on figure 194. b. Cleaning and Inspection. (1)   Clean     all     parts     with     an     approved cleaning solvent. (2)   Inspect the window mounting gasket for damage   and   inspect   glass   for   cracks and chipped edges. (3)   Replace damaged parts as necessary. c. Installation.  Install the side window glass as illustrated on figure 194. 316.  Engine Access Panel a. Removal.  Remove the engine access panel as instructed on figure 195. b. Cleaning, Inspection, and Repair. (1)   Clean     all     parts     with     an     approved cleaning solvent. (2)   Inspect   the   access   panel   for   cracks, bends,   and   dents.      Weld   all   cracks. Replace an unrepairable panel. (3)   Repair   or   replace   damaged   parts   as necessary. c.  Installation.    Install  the  engine  access  panel as illustrated on figure 195. 317.  Operator's Seat a. Removal.  Remove the operator's seat from the cab as instructed on figure 196. b. Disassembly.      Disassemble   the   operator's seat  in  the  numerical  sequence  as  instructed  on  figure 197. c. Cleaning, Inspection, and Repair. (1)   Clean     all     parts     with     an     approved cleaning  solvent,  except  the  cushions. Use     soap     and     water     for     cleaning cushions. (2)   Inspect  the  cushions  for  torn  or  ripped covers  and  broken  springs.    Replace  a damaged cushion as necessary. (3)   Inspect  the  seat  frame  and  suspension for cracks, breaks, and bends. Straighten bends and weld all cracks or breaks. (4)   Repair  or  replace  all  defective  parts  as necessary. d. reassembly.        Reassemble   the   operator's seat   in   the   reverse   of   the   numerical   sequence   as illustrated on figure 197. e. Installation.      Install  the  operator's  seat  as illustrated on figure 196. 318.  Cab Operator's Door a. Removal. Remove the carrier cab operator's door as instructed on figure 198. b. Cleaning, Inspection, and Repair. (1)   Clean     all     parts     with     an     approved cleaning solvent. (2)   Inspect door for bends, dents, or broken hinges.    Replace  a  defective  door  as necessary. (3)   Repair   or   replace   damaged   parts   as necessary. c. Installation.  Install the carrier cab operator's door as illustrated on figure 198. 252