TM 5-3810-207-20/TO 36C23-3-37-12 CHAPTER 3 MAINTENANCE INSTRUCTIONS Section I.  SPECIAL TOOLS AND EQUIPMENT 13.  Special Tools and Equipment There    are    no    special    tools    or    equipment    for organizational maintenance of the crane-shovel. 14.  Organizational Maintenance Repair Parts Organizational  maintenance  repair  parts  are  listed and illustrated in TM 5-3810-207-20P. Section II.  LUBRICATION 15.  General This section contains instructions for the lubrication of  the  carrier  wheel  bearing  assemblies  and  for  starter service.    Refer  to  the  current  lubrication  order  for  the proper  time  interval  and  type  and  grade  of  lubricant  to be used. 16.  Lubricating Wheel Bearing Assemblies a. Front Wheel Removal and Disassembly. Remove  and  disassemble  the  front  wheel  as  instructed in paragraph 284. b. Cleaning, Inspection, and Lubrication. (1) Clean    the    wheels,    hubs,    and    bearing assemblies    with    an    approved    cleaning solvent.    Dry  all  parts  thoroughly  with  a clean, lint-free cloth. (2) Inspect    all    wheel    parts    for    wear    and damage.  Replace unserviceable parts. (3) Pack  the  wheel  bearing  assemblies  with the type of grease indicated on the current lubrication order. c. Front Wheel Reassembly and Installation. Reassemble  and  install  the  front  wheel  as  instructed  in paragraph 284. 17.  Starter (Crane) a. Starter Removal.    Remove  the  crane  starter  as instructed in paragraph 78. b. Cleaning, Inspection, and Lubrication. (1) Clean     the     starter     with     an     approved cleaning solvent and dry thoroughly. (2) Inspect  the  starter  for  breaks  and  other damage.  Replace defective starter. (3) Lubricate the starter with the type lubricant  specified  on  current  lubrication order. c. Starter  Installation.    Install  the  crane  starter  as instructed in paragraph 78. 18.  Starter (Carrier) a. Starter Removal.  Remove the carrier starter as instructed in paragraph 204. b. Cleaning, Inspection, and Lubrication. (1) Clean     the     starter     with     an     approved cleaning solvent and dry thoroughly. (2) Inspect  the  starter  for  breaks  and  other damage.  Replace a defective starter. (3) Lubricate   starter   with   the   type   lubricant specified on current lubrication order. c. Starter Installation.    Install  the  carrier  starter  as instructed in paragraph 204. 17