TM 5-3810-231-12
28. Maintenance
remove cold weather starting aid.
b. Disassembly.
Refer to figure 12C and
disassemble starting aid control valve.
c. Cleaning, Inspection, and Repair.
(1) Clean all parts with an approved cleaning
solvent and wipe dry with a lint-free cloth,
or air dry with low pressure compressed air.
(2) Use low pressure compressed air to
remove foreign particles lodged in screen
of orifice.
(3) Inspect all parts for distortion, deterioration,
or other damage.
(4) Replace all damaged or defective parts.
starting aid control valve.
install cold weather starting aid.
28.1 Moisture Evaporator Kit
a. General.
The moisture evaporator kit filters
moisture from system air before it enters forward control
system.
with alcohol, and replace.
Figure 12 - Continued.
c. Removal. Disconnect tubing, remove mounting
hardware, and remove moisture evaporator from
fuel into intake manifold. Wait three seconds, then
mounting bracket.
engage starter. Repeat a second shot while starter is
d. Installation.
Install moisture evaporator on
turning engine. If engine falters after starting, give it extra
mounting bracket and secure with mounting hardware.
shots to keep it running.
Connect tubing. Fill bowl as directed in b. above.
Caution
Do not turn engine with starter for
more than 30 seconds at one time. Let
starter cool for at least two minutes
before trying another start, and avoid
damage to starter.
25
