TM 5-3810-231-12
CHAPTER 3
OPERATOR AND ORGANIZATIONAL MAINTENANCE INSTRUCTIONS
Section I. SPECIAL TOOLS AND EQUIPMENT
Tools and repair parts issued with or authorized for
29. Special Tools and Equipment
the Model 1125, 60 Ton, Crawler Crane are listed in the
No special tools or equipment are required by the
operator or organizational maintenance personnel for
31. Organizational Maintenance Repair Parts
maintenance of the Model 1125, 60 Ton Crawler Crane.
Organizational maintenance repair parts are listed
30. Basic Issue Tools and Equipment
and illustrated in TM 5-3810-231-20P.
Section II. LUBRICATION
32. General Lubrication Information
c. Points of Lubrication. Service the lubrication
points at proper intervals as illustrated in figure 13.
a. This section contains a reproduction of the
Caution
Lubrication Order and lubrication instructions which are
Over lubrication may cause equipment
supplemental to, and not specifically covered in the
Lubrication Order.
failure or damage to working parts.
b. The Lubrication Order shown in
figure 13 is an
exact reproduction of the approved Lubrication Order for
d. OSE Oil.
the Model 1125 Crane.
frequently, as oil consumption may
33. Detailed Lubrication Information
increase.
(2) The oil may require changing more
a. General. Keep all lubricants in closed container
frequently
than
usual
because
and store in a clean, dry place away from external heat.
Allow no dust, dirt or other foreign material to mix with the
formation will increase under cold weather
lubricants. Keep all lubrication equipment clean and
operation conditions.
ready for use.
e. Oil Filter Service. Service the oil filters as
b. Cleaning. Keep all external parts not requiring
lubrication clean of lubricants. Before lubricating the
f. Air Cleaner Service. Service the air cleaner as
equipment, wipe all lubrication points free of dirt and
grease. Clean all lubrication points after lubricating to
g. Water Corrosion Resistor Service. Service the
prevent accumulation of foreign matter.
engine water corrosion resistor as illustrated in figure 16.
27