TM 5-3810-231-12
1
Cotter pin
25
Screw with nut
50 Plain washer
2
Machine screw
26
Wire cleat
51 Foot throttle pedal
3
Nut
27
Machine screw nut
52 Mounting bracket
4
Trunnion
28
Clip
53 Bracket
5
Nut
29
Bracket
54 Hand throttle assembly
6
Lockwasher
30
Jam nut
55 Yoke pin
7
Capscrew
31
Handlebar grip
56 Adjusting yoke end
8
Throttle lever
32
Machine screw
57 Nut
9
Nut
33
Handlebar grip retainer
58 Lockwasher
10
Lockwasher
34
Sleeve assembly
59 Capscrew
11
Governor control clamp
35
Machine screw
60 Quadrant
12
Capscrew
36
Plunger assembly
61 Spacer
13
Capscrew
37
Control cable
02 Nut
14
Lockwasher
38
Throttle body adapter
63 Lockwasher
15
Bracket
39
Foot throttle assembly
64 Capscrew
16
Cotter pin
40
Yoke pin assembly
65 Lever
17
Pin
41
Adjusting yoke end
66 Compression spring
18
Plain washer
42
Hex nut
67 Roller
19
Hex nut
43
Hex nut
68 Nut
20
Bracket
44
Plain washer
69 Lockwasher
21
Control cable
45
Accelerator rod
70 Capscrew
22
Bracket
46
Spring
71 Handle
23
Throttle lever
47
Eye bolt
72 Lever shaft
24
Governor control
48
Cotter pin
73 Bracket
lever assembly
49
Pin
74 Cover plate
Figure 31 - Continued.
(3) Repair or replace damaged or defective
top of valve stem or crosshead, and turn
parts.
screw down until lever touches gauge.
Lock adjusting screw in this position with
c. Reassembly and Installation. Reassemble and
jam nut. Tighten nut to 70/80 foot pounds
install air cleaner as instructed in figure 30.
with torque wrench.
(2) Always make valve adjustment after
68. Throttle and Governor Controls
injectors are adjusted. Valve clearances
a. Removal. Remove throttle and governor controls
are as follows: Intake valves, Cold or
as instructed in figure 31.
Warm, .016"-Hot, .014"; Exhaust Valves,
b. Cleaning, Inspection and Repair.
Cold or Warm, .029"-Hot, .027".
(1) Clean all parts with a n approved cleaning
solvent, and dry thoroughly.
67. Air Cleaner
(2) Inspect for cracks, breaks or other damage.
a. Removal and Disassembly.
Remove and
(3) Repair or replace damaged or defective
disassemble air cleaner as instructed in figure 30.
parts.
b. Cleaning, Inspection and Repair.
c. Installation. Install throttle and governor controls as
(1) Clean - all parts in an approved cleaning
instructed in figure 31.
solvent and dry thoroughly.
(2) Inspect all parts for wear or damage,
especially the gaskets.
Section VIII. LUBRICATION SYSTEM
69. General
70. Lubricating Oil Filter
The lubrication oil system components maintain the
proper oil pressure required at the various operating
units, filter the oil, maintain the oil at proper operating
b. Cleaning, Inspection and Repair.
temperature, and provide facilities for draining,
(1) Clean all parts in an approved cleaning
replenishing, and measuring lubricating oil in the
solvent and dry thoroughly.
(2) Inspect for cracks, breaks or other damage
67
