long pacer. Install roller bearing (111) and drive in place.
output shaft (138) in transmission case to the Input aide
(front) with longer offset of gear hub to the front. Position
NOTE
large output gear (149) in transmission case to the rear
Bearing must be driven in tight.
with longer offset of gear hub to the rear. Insert output
Check Check long spacer on shaft.
shaft through the rear bore of case and through large
When spacer cannot be turned by
and small output gears. Block output haft and install
hand, stack up between the front and
front taper bearing cone (135) (large diameter of taper
rear bearing is tight. DO NOT attempt
inward) on output s-ht until bearing shoulders against
to draw bearing up tight with bearing
small output gear. Install bearing cups (134, 151) over
lock nits. Remove shaft pusher. This
front and rear bearing
was left on only to hold shaft while
(b) Install new O-ring (5, fig. 5-10) on
installing roller bearing.
disconnect housing (7). lubricate O-ring with type "A"
(d) Install 1st and 2d clutch supports
automatic transmission fluid.
Install disconnect
(85, 121). Align holes in clutch supports with holes in
assembly on output shaft.
Secure disconnect
transmission case and install self locking screws (84),
assemembly to transmission case with screws (21) and
(122). Tighten screws 70 to 85 ft lbs. torque.
lockwashers (22). Tighten 46 to 5 lbs. torque.
(4) Reassembly of the output shaft.
(a) Press taper bearing cone (10) (large
diameter of taper inward over threaded end of output
gear (137) against shoulder on shaft. Position small
5-23
