b. Cleaning, Inspection and Repair.
(1) Clean all metal parts with an approved
cleaning solvent and dry thoroughly.
(1) Clean all parts with an approved cleaning
(2) Inspect rod, pistons, and cylinder for
solvent and dry thoroughly.
cracks, scoring or excessive wear. Repair or replace
(2) Inspect filler assembly and strainer for
defective parts.
damage. Replace parts as necessary.
(3) Inspect packing and 0-rings. Replace as
(3) Inspect tank for cracks, breaks, or other
necessary.
damage. Repair or replace defective tank.
d. Reassembly.
c. Installation.
(1) Model 2380. Install the hydraulic reservoir
(1) Model 2380. Reassemble utility blade
hydraulic cylinder in reverse of numerical sequence
tank as illustrated on figure 5-38A.
shown on figure 5-39A.
(2) Model 2385. Install the hydraulic reservoir
(2) Model 2385. Reassemble utility blade
tank as illustrated on figure 5-38B.
hydraulic cylinder as shown on figure 5-39B.
5-30. Utility Blade Hydraulic Cylinder
NOTE
a. Removal. Remove hydraulic cylinder (TM 5-
When reassembling the utility blade
3810-232-12).
b. Disassembly.
hydraulic cylinder tighten piston
(1) Model 2380. Disassemble utility blade
attaching nut (4) to 600 to 700 foot-
hydraulic cylinder in numerical sequence as shown on
pounds torque and tighten threaded
end cap (2) to 10 or 12-foot-pounds
(2) Model 2385. Disassemble utility blade
hydraulic cylinder in numerical sequence as shown on
e. Installation. Install utility blade hydraulic cylinder
(TM 5-3810-232-12).
c. Cleaning, Inspection and Repair.
5-80
