TM 5-3810-288-12
STEP 1
LOOSEN LOCKNUTS (4) WHICH SECURE ADJUSTING BOLTS (4).
STEP 2
TURN ADJUSTING BOLTS OUT OF CONTACT WITH CLUTCH BANDS. CLUTCH BANDS MUST BE
CENTERED IN CLUTCH DRUM. USE ADJUSTING BOLTS (4) TO CENTER CLUTCH BANDS.
TIGHTEN LOCKNUTS.
STEP 3. LOOSEN LOCKNUT ON CYLINDER ROD.
STEP 4. TURN CYLINDER ROD OUT UNTIL A PULL OF 15 TO 20 POUNDS ON A SPRING SCALE IS NEEDED
TO ENGAGE THE CLUTCH. TIGHTEN LOCKNUT.
NOTE:
ONLY STEPS 3 AND 4 ABOVE ARE NECESSARY TO ADJUST FOR LINING WEAR. USE
COMPLETE PROCEDURE ONLY WHEN CLUTCH HAS BEEN REMOVED AND REPLACED.
ME 3810-288-12/3-9
Figure 3-9. Adjusting /rot and rear drum clutch.
3-11