TM 5-1310-288-12
STEP 1.
LOOSEN LOCKNUTS WHICH SECURE ADJUSTING BOLTS.
STEP 2
TURN ADJUSTING BOLTS OUT OF CONTACT WITH CLUTCH BAND. CLUTCH BAND MUST BE
CENTERED IN CLUTCH DRUMS. USE ADJUSTING BOLTS TO CENTER CLUTCH BAND. TIGHTEN
LOCKNUTS.
STEP 3.
LOOSEN LOCKNUT ON CYLINDER ROD.
STEP 4.
TURN CYLINDER ROD OUT UNTIL A PULL OF 15 TO 20 POUNDS ON A SPING SCALE IS NEEDED
TO ENGAGE THE CLUTCH. TIGHTEN LOCKNUT ON CYLINDER ROD.
NOTE:
ONLY STEPS 3 AND 4 ABOVE ARE NECESSARY TO ADJUST FOR LINING WEAR. USE
COMPLETE PROCEDURE ONLY WHEN CLUTCH HAS BEEN REMOVED AND REPLACED.
ME 3810-288-12/3-10
Figure 3-10. Adjusting boom hoist clutch.
3-12
