TM 5-3810-288-12
CHAPTER 7
OPERATOR'S AND ORGANIZATIONAL MAINTENANCE INSTRUCTIONS
Section I. OPERATOR'S AND ORGANIZATIONAL MAINTENANCE
REPAIR PARTS, TOOLS, AND EQUIPMENT
b. No special tools or equipment are required by the
7-1. Tools and Equipment
operator or organizational maintenance personnel for
a. Basic issue tools and repair parts issued with
maintenance of the Model M320T Truck Crane.
or authorized for the Model M320T Truck Crane are
listed in the Basic Issue Items List, Appendix B of this
manual.
Section II. LUBRICATION
7-2. General Lubrication Information
For general lubrication instructions see paragraph 3-2.
Figure 7-1. Lubrication chart. (Not used) See LO 5-3810-88-12.
7-3. Detailed Lubrication Information
Section III. PREVENTIVE MAINTENANCE CHECKS AND SERVICES
7-4. General
To insure that the Model M320T Truck Crane is ready for
ceased. Stop operation immediately if a deficiency is
noted during operation which would damage the
operation at all times, it must be inspected systematically
equipment if operation were continued. All deficiencies
so that defects may be discovered and corrected before
and shortcomings will be recorded together with the
they result in serious damage or failure. The necessary
corrective action taken on DA Form 2404 at the earliest
preventive maintenance checks and services to be
possible opportunity.
performed are listed and described in paragraph 7-5.
The item numbers indicate the sequence of minimum
7-5. Preventive Maintenance Checks and Services
inspection requirements. Defects discovered during
See table 7-1 for a tabulated listing of preventive
operation of the unit will be noted for future correction, to
maintenance checks and services.
be
made
as
soon
as
operation
has
7-1
