TM 5-3810-288-12
Figure 7-42. Rear wheel brake chamber, removal and replacement.
attached to the compressor intake manifold and the
no reasonable possibility of corrosion or other external
compressor governor.
damage so long as the reservoir is kept properly painted.
Refer to TM 9-213 for painting information. However,
when possible to do so without placing the machine out
alcohol evaporator. Be sure lines to the evaporator
of operation for an extended period of time, it is
are secure, and check to see that air bubbles can be
recommended that the reservoirs be completely drained
seen passing through the evaporator when the
by removing the lowest hose connection and allowing all
compressor is compressing air. To do so, remove
air, water, sediment, and oil trapped in the tank to drain.
filler cap.
f. Air Reservoirs.
(1) General. The only reason for removing or replacing
lines, and remove the air reservoir. There are three air
reservoirs used on this ma-
a reservoir normally will be puncture of the reservoir
from an outside source. There is
7-49
