TM 5-3810-288-12
Figure 7-45. Air compressor, removal and replacement. (Sheet 1 of 2)
(e) Recheck the starting and stopping points of the
(e) Refer to figure 7-45 and disconnect the oil line to
compressor as described above. Then tighten
the compressor.
the adjusting screw locknut. Install the governor
(f) Refer to figure 7-45 and disconnect the water
cover.
lines to the compressor at the swivel fittings.
(a) Refer to figure 7-34 and release fan belt tension.
(g) Remove the compressor mounting bolts and
Lift the belts off the compressor drive sheave.
lockwashers and remove the air compressor.
(b) Refer to figure 7-45 and disconnect the two
alcohol evaporator lines, which go to the air
in figure 7-45. Replace all gaskets, and check
compressor intake manifold and governor, at the
governor adjustment as described in this paragraph
swivel fittings.
before returning the machine to service. Check all
(c) Remove the compressor discharge air line by
water, air and oil lines to be sure there are no leaks.
Refer to figure 7-34 and adjust the fan belt tension,
removing the attaching nuts and lock-washers.
(d) Remove the compressor intake air line by
since the fan belts also drive the compressor. h.
Dummy Couplings.
removing the attaching bolts and lockwashers.
7-51
