TM 5-3810-288-12
also includes the Windshield wiper motor and the low air
Note. It is very important that all rust, corrosion, and
pressure alarm, since these items are tied into the air
accumulated dirt be removed from the ring and its setting
system.
All items are located on the drawing in
surface on the wheel rim.
relationship to their location on the machine. However,
(5) With the ring installed, turn the tire over, so that the
the items contained in the gauge board in the operators
ring side is touching the ground. Using an air hose from
cab are turned 90 degrees. If this were not done, all of
the side opposite the ring, inflate the tire.
the gauge board mounted items would be seen from the
side, and would hide each other.
The fifteen air
Warning: Always inflate the tire from the side
connections which enter the operators cab as shown in
opposite the ring. If the ring is improperly installed,
part 1 of the illustration are connected to like numbered
air pressure may cause it to fly off the wheel, and
connections on sheet 2, which is the forward end of the
serious injury to personnel may result.
carrier. Items identified by both a number and a letter of
the alphabet (for example 3c) indicate that a detailed
(6) Install the wheel-tire on the vehicle.
view of that item is to be found on the last sheet of figure
7-46. Air Brake System
brake system for the entire carrier. It
7-44
