TM 5-3810-294-34
CHAPTER 7
REPAIR OF CRANE CAB COMPONENTS AND CONTROLS
Section I. REPAIR OF SWING BRAKE CONTROL STAND
7-1. Description
a. Remove the compensator (16, fig. 7-1) from compensator
The swing brake control stand provides for an interface
bracket (20). Refer to paragraph 7-6).
between the operator and the swing brake. The swing
b. Remove cotter pins (19 and 25) from pins (23 and 24) and
brake lever is equipped with a toggle arrangement which
press pin (23 and 24) out of compensator bracket (20). Note that
keeps the brake applied until released by the operator.
spacers (4, 11, and 14) will be free and can be removed from the
7-2. Disassembly
compensator bracket.
c. Remove the remaining parts of the swing brake contro
Disassemble the swing brake control stand as follows:
stand as necessary.
KEY to fig. 7-1.
1. Hand lever knob
2. Hand lever
3. Grease fitting
4. Spacer (2)
5. Bearing
6. Flat washer
7. Link (2)
8. Spacer (4)
10. Bushing
11. Spacer (2)
12. Link (2)
13. Rod end
14. Spacer
15. Jam nut
16. Compensator
17. Capscrew (3)
18. Pin (2)
19. Cotter pin (4)
20. Compensator
bracket
21. Lockwasher (3)
22. Nut (3)
23. Pin
24. Pin
25. Cotter pin (2)
26. Capscrew
27. Jam nut
7-1
