TM 5-3810-295-34
c. Remove two screws (10), lock washers (11) and spring housing (12). Then remove spring retainer (13), shims
(14), retainer stops (15) and (16), spring (17), spring plunger (18), spring guide (19), guide bushing (20), and gasket (21).
d. From the opposite side of the control housing, remove buffer screw (22) and nut (23).
e. Rotate the shaft until adjusting screw (24) is accessible through the housing opening. Remove screw (24), nut
(25), lever assembly (26), and lever pin (27).
f Remove bearing screw (28) and bearing (29) from the operating shaft.
g. Remove lock nut (30) from the drive shaft, and remove gear (31) and Woodruff key (32). Slide gear spacer
(33) from the shaft, then remove two screws (34), lock washers (35) and lever fork (36) from weight housing (45).
h. Shaft tube (7) and operating shaft (38) can now be removed along with control housing (39).
3-24
