TM 5-3810-295-34
h. Install bearing caps and measure the main bear-
Install gasket (26), adapter (25), nut (24), and guide (23).
Install dipstick (22).
ing bores. The main bearing bores must be within 3.251
c. Affix a new gasket (13) and install end plate (12)
to 3.252 inches. If the bores are not within these limits,
at the rear of the block. Secure with screws (9) and (10)
replace the block.
i. Check all machined surfaces for nicks and burrs.
and lock washers (11). Install dowel pin (14) in the rear
end plate.
Clean up nicks and burrs with a file. Check threaded
d. Install new gasket (8) and air box cover (7).
holes in the block. Clean up damaged threads with a
Secure with screws (5) and lockwashers (6).
tap.
e. Install new gasket (4) and access cover plate (3).
Secure with bolts (1) and lock washers (2).
4-43. Reassembly and Installation
f. Refer to chapter 3 and install engine accessories
a. Refer to figure 4-19. Install pipe plugs (18) and
and associated assemblies.
(19), and drain cock (17). Install dowels (15) and (16) in
g. Refer to chapter 2 and install the engine in the
the cylinder block.
crane.
b. Install a new filter (31), gasket (30), and pipe as-
sembly (29). Secure with bolts (27) and washers (28).
4-27/(4-28 blank)
