TM 5-3810-295-34
1 Lock wire
8 Hub and sprocket
15 Cap screw (12)
22 Bearing
2 Cap screw
9 Spacer
16 Seal
23 Seal
3 Washer
10 packing
17 Shim
24 Packing
4 Bevel pinion
11 Seal
18 Shim
25 Shim
5 Spacer
12 Bearing
19 Shim
26 Shim
6 Bearing
13 Drum
20 Swing clutch housing
27 Grease fitting (2)
7 Shaft
14 Lock ring
21 Bearing
28 Relief fitting (2)
Figure 5-11. Horizontal swing shaft assembly--exploded view.
d. Inspect and smooth all seal seating surfaces
5-45. Cleaning, Inspection and Repair
with a fine oil stone or crocus cloth.
a. Clean all metal parts in cleaning solvent, Federal
e. The horizontal swing shafts use the identical
Specification P-D-680, or equivalent, before inspect-ing.
clutch as the reversing shaft assembly. Refer to
b. Replace all seals, gasket, deformed shims,
paragraph 5-39c for clutch repair.
pack-ing, and other expendable parts.
c. Inspect all parts for wear, scoring, cracks, or any
other visible signs of damage excessive wear. Replace
5-46. Reassembly
any parts not in good condition. Inspect gear teeth for
a. Refer to figure 5-11 and install seal (23) and.
severe wear, pitting, and cracks, especially at the root of
packing (24) in housing (20).
the teeth.
b. Warm inner race of bearing (22) in oil bath and
install the race on hub and sprocket (8). Pack the inner
race of bearing (22) with GAA grease, and install the
5-22
