TM 5-3810-295-34
(3) Replace all damaged or defective parts.
f. Installation Refer to TM 5-3810-295-12 and in-
e. Reassembly. Refer to figure 20-4 and reassemble
stall the control valve as described.
the control valve as follows.
20-12. Outriggers Directional Control
(1) Install valve spool (9) and spool cap (8) into
Valve
valve body (10).
a. Removal. Refer to TM 5-3810-295-12 and remove
(2) Install check valve (7), plug (6) and relief valve
the outrigger directional control valve.
(5).
b. Disassembly. Refer to figure 20-5 and disassemble
(3) Assemble spool seal (4) over relief valve (5) on
the control valve as follows.
valve body (10) with screws (3).
(1) Remove plug and ring (1) and check valve (2)
(4) If removed, assemble identification plate (2) to
from valve body (8).
valve body with screws (1).
Figure 20-5.
1
Plug and ring
2
Check valve
3
Spool Cap
4
Direction spool
5
Relief valve
6
Screw
7
Name plate
8
Valve body
equivalent) and dry thoroughly.
(2) Remove spool cap (3), direction spool (4) and
(2) Inspect parts for cracks, scoring, corrosion, or
relief valve (5) from valve body (8).
other damage and defects.
(3) If necessary remove screws (6) and lift
(3) Replace all damaged or defective parts.
name plate () from the valve body.
c. Cleaning Inspection and Repair.
d.Reassembly. Refer to figure 20-5 and reassemble
the control valve as follows:
(1) Clean all metallic parts of the control valve
(1) If removed, assemble name plate (7) to valve
with cleaning solvent (Fed. Spec. P-D-680, or
