TM 5-3810-300-24&P-3
OIL COOLER 4.4
Fig. 3 - Lubricator Oil Cooler and By-Pass Valve Details and Relative Location of Parts.
2.
Affix new gaskets to each side of the core, and
at the same time locating the seal and clamp. Tighten
position the core inside the housing.
the clamp (Fig. 1).
3.
Set the housing with cooler core against the adaptor
4.
Affix a new gasket to the oil cooler water inlet
and secure with bolts and lock washers
connector and secure with bolts and lock washers.
Page 295