TM 5-3810-300-24&P-3
14.3 LIMITING SPEED GOVERNOR ADJUSTMENT
Fig. 8 - Fuel Modulator Assembly
266
Spring--Modulator Torsion
278
Bracket and Air
281
Spring--Piston
284 Cam--Fuel Modulating
275
Pipe--Fuel Inlet
Cylinder
282
Retainer--Piston Spring
285 Lever and Roller
276
Tube--injector Control
279
Tube Assembly--Air Inlet
283
Retainer Ring--Piston
Assembly
277
Rocker Shaft
280
Piston--Fuel Modulator
Spring
286 Bolt--1/4" - 20 "U"
Adjusting the rod in this manner will permit the engine
governor to move the injector fuel control racks into the
full-fuel position without coming to the end of the slot in
the end of the air cylinder fuel shut-off rod.
Adjust Engine Load Limiting Device
After adjusting the engine governor, adjust the load
limiting device in accordance with the following
procedure.
1
Loosen the load limit screw lock nut (Fig 10).
2
Back the load limit screw out of the adjusting screw
plate until approximately 1" of the screw is below
the plate.
3
Adjust the load limit screw lock nut so that the
bottom of the lock nut is 1 3/4" from the bottom of
Fig. 9 Air Cylinder Used with Limiting Speed Governor
the load limit screw.
Page 392