TM 5-3810-300-24&P-3
14.3 LIMITING SPEED GOVERNOR ADJUSTMENT
5
Thread the load limit screw into the adjusting screw
plate until the lock nut "bottoms" against the top of
the plate.
6
Hold the injector rack control tube in the "full fuel"
position, place the load limit lever against the
bottom of the load limit screw, then tighten the load
limit lever clamp bolts.
7
Check to ensure that the injector racks will just go
into the "full fuel" position--readjust the load limit
lever, if necessary.
8
Hold the load limit screw to keep it from turning,
then "set" the lock nut until the distance between
the bottom of the lock nut and the top of the
adjusting screw plate corresponds to the markings
on the adjusting screw plate.
9
Thread the load limit screw into the plate until the
lock nut "bottoms" against the top of the plate.
10
Hold the load limit screw to keep it from turning,
then tighten the lock nut to secure the setting.
Occasionally, it may be necessary to vary the "setting"
Fig. 10 - Load Limiting Device Mounted on Engine
very slightly in accordance with the actual performance
required of the engine.
4
Loosen the load limit lever clamp bolts so that the
lever is free to turn on the injector rack control tube.
Page 393
