PREVENTIVE MAINTENANCE
SECTION V
INSPECT ENGINE AND TORQUE
Proceed as follows to tighten the clutch (see Figure 5E-7):
CONVERTER MOUNTS
1. Remove access cover from clutch housing.
Check the engine and torque converter mounting bolts and
2. Disengage clutch Rotate clutch assembly until adjust-
the condition of the mounting pads Tighten and repair as
ment collar lock pin is accessible.
necessary.
3. Release the adjustment collar lock by pulling out on pin
and rotate adjustment collar and toggle adjustment clock-
wise to tighten until the engagement force shown in the
CLEAN AIR BOX CHECK VALVES
write-up earlier is attained.
Remove and clean the air box check valves in solvent and
blow out lines with compressed air. Inspect for leaks after
servicing.
Always be sure the adjustment collar lock pin
is engaged in one of the 24 holes in the hub
plate or the clutch will lose adjustment.
NOTE
Check that clutch actuator IS properly adjusted. See
Subsection 4B of Shop Manual.
4. Install access cover
Figure 5E-7. Clutch Adjustment
5-26