Figure 4C-7. Spanner Wrench for Input Disconnect Clutch Lock Nut
tile mineral spirits, paint thinner, or by
found, the converter must be thoroughly
the steam cleaning method.
cleaned.
All
oil
lines
and
cooler
pas-
sages should be cleaned.
Parts should be dried with compressed
air. Steam cleaned parts should be oiled
CLEANING PARTS. All metallic parts
immediately after drying.
except bearings should be cleaned thor-
oughly with dry cleaning solvent, vola-
Clean oil passages by working a piece of
wire back and forth through the pas-
sages and flushing them with cleaning
solvent or paint thinner. Dry the pas-
s a g e s with compressed air.
Examine parts, especially oil passages,
after cleaning to make certain they are
entirely clean. Reclean them if neces-
sary.
CLEANING BEARINGS.
Thoroughly
wash bearings that have been in service
in dry cleaning solvent, volatile mineral
spirits or paint thinner.
If the bearings are particularly dirty or
filled with hardened grease, soak them in
solvent before trying to clean them.
Figure 4C-8. Puller and Sleeve for
C o n v e r t e r Pump Bearing
4C-12