is important to keep bearings clean dur-
Before inspection, oil bearings with the
ing installation and removal. Observance
same type of oil that will be used in the
of the following rules will do much to in-
converter.
sure maximum bearing life:
NOTE
Do not remove the wrapper from new
bearings until ready to install them.
Never dry bearings with com-
pressed air. Do not spin bearings
Do not remove the grease in which new
while they are not lubricated.
bearings are packed.
Do not lay bearings on a dirty work-
Since dirt or grit in ball bearings is usu-
bench; place them on clean paper.
ally responsible for bearing failures, it
USE
NUMBER
NAME
To remove n e e d l e b e a r i n g f r o m p u m p b o d y ;
J 4850
Charging oil pump
needle bearing in pump driven
to install
needle bearing re-
gear; to install sleeve into pump body
placer
To install drive shaft needle bearing in
J 4523-A
Charging oil pump
pump body
drive shaft needle
bearing replacer
To remove and install snap rings
J 8039
Snap ring pliers
To remove oil pump rear bearing sleeve
J 4852
Charging oil pump
from oil charging pump
rear bearing sleeve
puller
Used with adapter J 8117 to remove charg-
J 23907-1
Charging oil pump
ing oil pump idler gear shaft from con-
idler gear shaft re-
verter housing
mover (slide hammer
puller)
Used with puller J 23907-1 to remove
J 8117
Charging oil pump
charging oil pump idler gear from convert-
idler ear shaft re-
er housing
mover (adapter)
To press pump hub oil seal into converter
Converter pump hub
J 7475
housing
seal replacer
To remove and install stator roller race
J 6534-02
Spanner wrench
retainer nut
To support converter during overhaul
TSD 20183
Converter
overhaul
To remove and install overcenter discon-
TSD 20231
Overcenter discon-
nect clutch lock nut
nect clutch lock nut
wrench
T o remove converter pump bearing
Puller and sleeve
for converter pump
bearing
Table 4C-3. Special Tools
ings with clean paper or cloth to keep
If assembly is not to be completed at
out dust.
once, wrap or cover the exposed bear-
4C-14