and pin area will tend to pull the lubri-
cant into the cavity.
NOTE
H e a t the Cindol 1705 in a small pail
with a screen insert. The screen
will prevent the cam followers from
t o u c h i n g the bottom of the pail. and
avoid the possibility of contam-
ination.
Install used cam followers and push rods
in their original locations. Refer to
Figure 11B-45 and proceed as follows:
Figure 11B-46. Installation of Cam
Followers
2. Assemble the serrated lower spring
seat (Figure 11B-42 on page 11B-29),
spring and upper spring seat on the
push rod.
3. Place a flat washer over the upper
spring seat and start the lock nut on the
push rod. Place tool J 3092-01 on the
push rod between the washer and the
upper spring seat and place the push
rod assembly in the cam follower. Then
thread the lock nut on the push rod until
the spring is compressed sufficiently to
permit
the
spring
retainer
to
be
installed. Install the retainer with the
tangs facing the notch in the cylinder
head.
4. Remove the nut, flat washer and tool.
Then reinstall the lock nut and thread it
a s far as possible on the push rod.
CYLINDER HEAD REMOVED FROM EN-
GINE. If the cylinder head has been re-
Figure 11B45. Valve Operating
moved from the engine, proceed as
Mechanism
follows (see Figure 11B-45):
CYLINDER HEAD ON ENGINE. Use the
1. Assemble the serrated lower spring
following procedure if the cylinder head
seat (Figure 11B-42 on page 11B-29),
has not been removed from the cylinder
block
spring, upper spring seat and lock nut
on the push rod.
1. Note the oil hole in
the bottom of the
2. With the spring retainer in place in
cam follower. With the
oil hole directed
the cylinder head, slide the push rod as-
away from the exhaust
sembly in position from the bottom of the
slide the cam follower
in position in the
head.
cylinder head.
11B-31
Engine (Less Major Assemblies)
