SECTION III
REPAIRPARTS SUPPLY
General:
28.
a. The basic policies and procedures in AR 710-2 and AR 725-50 are
generally applicable to repair parts management for NDI items.
b. Manufacturers' part manuals are furnished with NDI items instead of
Department of the Army Repair Parts and Special Tool List (RPSTL).
c. National Stock Numbers (NSN) are initially assigned only to PLL/ASL
parts, i.e., engine, starter, gauges, etc. Additional NSN are assigned by
the Supply Support Activities as demand warrants.
d . A u t o m a t e d Processing (AUTODIN) of Federal Supply Code Manufacturer
( F S C M ) part number requisitions, w i t h o u t e d i t f o r m a t c h i n g N S N a n d e x c e p t i o n
data is authorized.
e . P r o p e r use of Direct Support System (DSS) project codes and weapon
system designator codes on parts requisitions is essential.
f . Repair parts are available from commercial sources for CONUS units
a n d may be purchased locally in accordance with AR 710-2 and AR 735-110.
P r e s c r i b e d Load/Authorized Stockage List (PLL/ASL) (See Appendix J):
29.
a . T h e PLL is a 15 day supply of parts recommended for initial stockage
at the organizational level of maintenance. Management of PLL items is
governed by AR 710-2 and local command procedures. PLL will be on hand at
the using organization on receipt of the end item. Selection of PLL parts
for overseas is based upon the receiving command's recommendations after
r e v i e w of TACOM prepared list in Appendix J. CONUS commanders receiving
this end item will establish stock through normal requisitioning process,
b. The ASL is an estimated 45 days supply of repair parts for support
units and activities. ASL will be on hand at the support activity in sufficient
time to allow using organizations time to request PLL supply to support this
end item. ASL selection for overseas is based upon the support of PLL which
w a s on the receiving command's recommendations. CONUS commanders in support
of this item will establish stocks through normal processes.
9
