TM5-3810-305-104.5.6.7.After correcting any defects revealed by in-spection and determining that the winch is ingood operating condition, spool cable (referto Chapter 4, Section V, Wire Rope Instruc-tions, page 4-28).Place a pipe or bar through the reel center.Mount the cable shipping reel with the barhorizontal on jacks or a suitable supportingstructure (Figure 2-5).Draw the cable from the top of the reel, inorder to avoid reverse bending as it is spooledonto the winch drum.Figure 2-5. SpoolingCableonWinchDrumICAUTIONILoops formed by overrun cancause kinks and dog legs in thecable, resulting in damage andpremature cable failure.8. Apply braking force to the reel flange toprevent overrun as the cable is being drawnoff.9. Using a timber or block, apply force againstthe shipping reel flange to provide the re-quired breaking force.Installing Cab Ie on WinchInstall cable on winch drum in accordance withthe following procedure:1.2.3.Position cable over boom tip sheave and routeback to winch drum.Position winch drum with cable anchor pocketon top.Insert cable into small opening of cablepocket. Loop cable around clamp and backinto pocket about 3/4 of the way through thepocket. Use cable clamp for 1/2 in. cable(refer to Koehring Commercial Parts Man-ual). Insert small end first. Pull on cable andthe clamp will slip into the pocket, securingthe cable (Figure 2-6).Figure 2-6. Securing Cable on Winch4. Rotate the drum slowly to insure that firstlayer of cable is evenly wound onto drum.2-4
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
