TM 5-3810-305-23
0127
INSPECTION
Inspect parts IAW General Maintenance Instructions (WP 0162).
END OF TASK
INSTALLATION
NOTE
Coat all parts with clean lubricating oil prior to assembly.
1.
Install plug (Figure 2, Item 1), check valve poppet (Figure 2, Item 22), spring (Figure 2, Item 21), new o-ring
(Figure 2, Item 20), and spring retainer (Figure 2, Item 19) in housing (Figure 2, Item 23).
2.
Install new o-ring (Figure 2, Item 3) and back-up ring (Figure 2, Item 2) on damper piston (Figure 2, Item 7).
3.
Install damper piston (Figure 2, Item 7) into spool (Figure 2, Item 15).
4.
Install new o-ring (Figure 2, Item 16) and back-up ring (Figure 2, Item 17) on spool (Figure 2, Item 15).
5.
Install spool (Figure 2, Item 15) and damper piston (Figure 2, Item 7) as a unit in housing (Figure 2, Item 23).
Center unit in housing while installing.
6.
Install cap plug (Figure 2, Item 18) in housing (Figure 2, Item 23).
7.
Install spring (Figure 2, Item 6), new o-ring (Figure 2, Item 5), and spring retainer (Figure 2, Item 4) in
housing (Figure 2, Item 23).
8.
Install pilot orifice (Figure 2, Item 12), new elbow with o-ring (Figure 2, Item 14) in housing (Figure 2, Item 23).
9.
Install spring (Figure 2, Item 8), ball (Figure 2, Item 9), new elbow with o-ring (Figure 2, Item 11) in housing
(Figure 2, Item 23). Ball should rest on spring.
10.
Install brake clutch assembly.
0127-4
03/15/2011Rel(1.8)root(maintwp)wpno(M00142)
