TM 5-3810-305-23
0164
RESTORING ENGINE TO SERVICE
1.
Remove the covers and tape from all the openings of the engine, fuel tank, and electrical equipment. Do not
overlook the exhaust outlet.
2.
Wash the exterior of the engine with fuel oil to remove the rust-preventive compound.
3.
Remove the paper strips from between the pulleys and belts.
4.
Check the crankcase oil level. Fill the crankcase to the proper level with the recommended lubricating oil
5.
Fill the fuel tank with the fuel specified.
6.
Close the drain cock and fill the engine cooling system with a clean antifreeze solution of 50% Base/50% water.
7.
Install and connect the battery (WP 0076).
8.
Service the air cleaner (WP 0046).
9.
The small amount of rust-preventive compound which remains in the fuel system will cause a smoky exhaust
for a few minutes.
END OF TASK
RESTORING TRANSMISSION TO SERVICE
WARNING
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low
toxicity material. However, it may be irritating to the eyes and skin. Use protective gloves and
goggles. Use in well-ventilated areas. Keep away from open flames and other sources of
ignition. Failure to follow this warning may cause injury to personnel.
If rust-preventative mixture was used in preparing the transmission for storage, use the following procedure to restore
the unit to service:
1.
Remove the tape from all openings and breathers.
2.
Wash off all the external grease with solvent.
3.
Add hydraulic transmission oil to proper level (WP 0153).
NOTE
It is not necessary to drain oil to remove the rust-preventive compound mixture from the
transmission.
If rust-preventative mixture was not used in preparing the transmission for storage, use the following procedure to
restore the unit to service:
1.
Remove the tape from all openings and breathers.
2.
Wash off all the external grease with solvent.
3.
Drain oil (WP 0022).
4.
Install new oil filter elements (WP 0022).
0164-5
03/15/2011Rel(1.8)root(maintwp)wpno(M00182)
