TM 5-3810-306-20STE/ICE1. INTRODUCTION.This section provides guidelines for the Simplified Test Equipment for Internal Combustion Engine (STE/ICE)cards developed for the RT875CC Container Crane. As developed, the cards and the design equipment effortrepresented thereon provide a powerful troubleshooting tool in both preventive and corrective maintenancecapacities.NOTERefer to Vehicle Test Meter (VTM) Operation and Maintenance Manual for the use and repair of theVTM.2.RT875CC VEHICLE TEST CARD (VTC).Pre-Test Inspection. Inspect the following crane components prior to beginning the test(s).a.Fan drive belt.b.Engine, transmission, and torque converter oil levels.c.Engine coolant level.d.Fuel level.e.Batteries, cables, and terminals.Procedure (DCA Mode)a.Open the engine left-side access door and remove the dust cap on the DCA connector box located on theframe adjacent to the engine.b.Connect the VTM to cable W1. Connect cable W1 to the DCA connector on the crane. See figure 1 on theRT875CC Vehicle Test Card (VTC)(Sheet 1). (Refer to page 3-57.)c.Enter the Vehicle Identification (VID) code using STE/ICE test 60.d.Perform the STE/ICE Confidence Test using test 66 (second entry 99).NOTERefer to TM 5-3810-306-10 as required for information or operator prompts (e.g., disengagepumps).e.Conduct the Vehicle Readiness Tests shown on the VTC, sheet 1.f.Perform the Optional Vehicle Test.Procedures (TK Mode)a.Connect VTM to the W5 cable.3-55
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
