WATER PUMP INSTALLATION

TURBOCHARGER AFTERCOOLER AND PIPING REPLACEMENT - cont

TM-5-3810-306-20 Container Crane 40-Ton Rough Terrain Model RTB75CC Manual
Page Navigation
154

TM 5-3810-306-20 WATER PUMP INSTALLATION TOOLS: General mechanic’s tool kit: automotive (5180-00-177-7033) SUPPLIES: Pump seal (Item 33, Appendix C) EQUIPMENT CONDITIONS: Disconnect ground cable at shunt. (Refer to page 8-109.) Fan drive belt removed. (Refer to page 7-23.) Radiator coolant drained. REMOVAL: 1. REMOVE WATER PUMP (1). a. Loosen capscrew at bottom of alternator securing link (5). b. Remove three capscrews (2 and 4)securing water pump (1) and alternator link (5). Allow link to fall out of way of water pump. c. Remove water pump (1) and seal (3). Discard seal (3). d. Clean mounting surfaces. INSTALLATION: 1. INSTALL WATER PUMP (1). a. Install new pump seal (3) on pump (1). b. Position water pump (1) on engine and install two capscrews (2 and 4) hand tight. c. Position alternator link (5) and water pump (1) mounting hole and install capscrew (4). d. Torque alternator link capscrew to 32 ft-lbs (43 Nm) and water. pump capscrews to 18 ft-lbs (24 Nm). 2. INSTALL FAN DRIVE BELT. (REFER TO PAGE 7- 23.) 3. SERVICE RADIATOR. (REFER TO TM 5-3810- 306-10.) 4. CONNECT GROUND CABLE AT SHUNT (REFER TO PAGE 8-109.) 5. START ENGINE AND CHECK FOR PROPER OPERATION. (REFER TO TM 5-3810-306-10.) CHECK FOR COOLANT LEAKS. END OF TASK 7-21

Privacy Statement
Press Release
Contact