TM 5-3810-306-20
SUPPLY, PRESSURE, AND RETURN LINES, SUPERSTRUCTURE
TOOLS:
General mechanics tool kit: automotive (5180-00-177-7033)
SUPPLIES: Loctite 545 (Item 13, Appendix C)
Preformed packings as required
EQUIPMENT CONDITIONS: Disconnect ground cable at shunt. (Refer to page 8-109.)
REMOVAL:
NOTE
Use
the
following
procedure
to
replace all hydraulic lines.
1.
REMOVE HYDRAULIC LINE.
a. Tag and disconnect both ends of hydraulic line.
Remove line and preformed packing. Note routing for
ease in installation.
b. Remove fittings and preformed packings as
necessary. Discard preformed packings.
c. Inspect all parts for damage and replace as
required.
INSTALLATION:
1.
INSTALL HYDRAULIC LINE.
a. Coat threads with Loctite 545 and performed
packings with clean hydraulic oil prior to
installation.
b. Install fittings and new preformed packing.
Tighten securely.
c. Route hydraulic line and connect both ends with
new preformed packings. Tighten securely.
2.
CONNECT GROUND CABLE AT SHUNT. REFER
TO PAGE 8-109.)
3.
START
ENGINE
AND
CHECK
HYDRAULIC
FUNCTIONS. CHECK FOR LEAKS. (REFER TO
TM 5-3810-306-10.)
END OF TASK
16-40