TM 5-3810-307-10
4.
Planetary Ends and Wheel Bearings.
Lube Type -
GO-85/140 [0F to +120F (-18C to 49C)]
GO-75 [-50F to +120F (-46C to 49C)]
Lube Interval -
Check every 200 hours. Drain and fill every 6000 miles (10,000 km), 1000
hours, or yearly.
Lube Amount -
2.5 quarts (2.4 liters)
Application -
Fill plug in axle end. The oil should be at the edge of the port opening
5.
Upper Kingpin Bearings.
Lube Type -
GAA
Lube Interval -
500 hours or 3000 miles (5000 km)
Lube Amount -
Until grease extrudes
Application -
4 fittings
6.
Lower Kingpin Bearings.
Lube Type -
GAA
Lube Interval -
500 hours or 3000 miles (5000 km)
Lube Amount -
Until grease extrudes
Application -
4 fittings
7.
Lockout Cylinder Pivot Pins.
Lube Type -
GAA
Lube Interval -
250 hours
Lube Amount -
Until grease extrudes
Application -
8 fittings
8.
Torque Rod Bushing.
Lube Type -
GAA
Lube Interval -
1000 miles (1600 km)
Lube Amount -
Until grease extrudes
Application -
2 fittings
9.
Not Used
10.
Engine.
Lube Type -
OE/HDO-15/40 [-5F to +120F (-21C to 49C)]
OEA [-50F to +10F (-46C to -12C)]
OE/HDO-40 [100F to +120F (38C to 49C)]
Lube Interval -
Check level daily. Drain and refill every 250 hours, 6000 miles (10,000 km), or
semi-annually. Change oil filter elements when changing oil.
NOTE
If oil filter elements are being changed in temperatures
at or below 30F (-1C) or oil is being changed to arctic
grade (OEA), use filter element installation procedures
annotated on cartridge plus 1/4 turn.
M-3 C-1
