TM 5-3810-307-24-1-1
LEGEND FOR FIGURE 2-1-7
1. Nut
25. Capscrew
49. Tube, refrig.
72. Star washer
2. Lockwasher
26. Washer
50. Tube, refrig.
73. Fan housing
3. Washer
27. Nut
51. Clamp
74. Fan housing
4. Hose cover
28. Lockwasher
52. Drier
75. Motor, evap.
5. Capscrew
29. Washer
53. Switch
76. Capscrew
6. Washer
30. Capscrew
54. Capscrew
77. Resistor
7. Cover
31. Washer
55. Capscrew
78. Locknut
8. Hose, refrig.
32. Spacer
56. Washer
79. Washer
9. Hose, refrig.
33. Compressor
57. Condenser coil
80. Strap
10. Capscrew
34. Capscrew
58. Locknut
81. Gasket
11. Control panel
35. Washer
59. Expansion valve
82. Drain hose
12. Capscrew
36. Capscrew
60. Capscrew
83. Frame, a/c
13. Washer
37. Star washer
61. Cover
84. Screw
14. Air conditioner
38. Washer
62. Evaporator coil
85. Switch assy.
15. Spacer, rubber
39. Ground wire
63. Capscrew
86. Louver
16. Spacer, rubber
40. Bracket
64. Washer
87. Capscrew
17. Seal, roof
41. Drive belt
65. Bracket
88. Drive plate
18. Nut
42. Clamp
66. Capscrew
89. Shim
19. Star washer
43. Motor, cond.
67. Ring
90. Snap ring
20. Washer
44. Retainer
68. Retainer
91. Cover
21. Capscrew
45. Fan
69. Fan wheel
92. Pulley
22. Nut
46. Nut
70. Fan wheel
93. Screw
23. Lockwasher
47. Star washer
71. Nut
94. Coil
24. Washer
48. Relay
(14) Tag and disconnect electrical connectors for motor (75) and resistor (77).
(15) Remove capscrews (63), washers (64), bracket (65), and evaporator fan motor (75) with fans from
air conditioner frame (83).
(16) Remove capscrews (66) and rings (67) from fan housings (73 and 74).
(17) Loosen setscrews, and remove retainers (68) and fan wheels (69 and 70) from shafts of motor (75).
(18) Remove nuts (71), lockwashers (72), and fan housings (73 and 74) from fan motor (75).
(19) Remove capscrews (76) and resistor (77) from fan housing (73).
(20) Remove locknuts (78), washers (79), and straps (80) from air conditioner frame (83).
(21) Remove plenum gasket (81) and drain hoses (82) from air conditioner frame (83).
(22) Remove screws (84) and switch assembly (85) from control panel (11).
(23) Unsnap louvers (86) from control panel (11).
b.
Assemble air conditioner unit (14, Figure 2-1-7) as necessary:
NOTE
Replace any o-rings on tube/hose fittings prior to connection.
2-1-41
