TM 5-3810-307-24-1-1
NOTE
Mark position of bracket (28) on compressor/motor mounting bracket to aid
installation.
(7)
If necessary, remove nuts (17), lockwashers (18), washers (19), capscrews (20), and bracket (28)
from compressor/motor mounting bracket.
d.
Remove motor as follows:
(1)
If necessary, remove screws (12, Figure 2-1-8) and access cover (13) from compressor/motor
mounting bracket.
(2)
If necessary, loosen capscrew (14) releasing tension on drive belt (15) and remove belt from motor
pulley.
CAUTION
Cap/cover all hydraulic openings to prevent entry of dirt and contamination of
hydraulic system.
(3)
Disconnect hydraulic hoses (29 and 30) from adapter (46) and tee (47) at top of motor (43).
(4)
Disconnect hydraulic hose (31) from tee (45) at rear of motor (43).
(5)
Remove hydraulic tubes (32 and 33) from elbow (44) and tee (45) at rear of motor (43) and adapters
(53 and 54) at valve (52).
(6)
Remove capscrews (34) and lockwashers (35), retainer (36), key (37), and pulley (38) from motor
(43).
(7)
Remove nuts (39), lockwashers (40), washers (41), capscrews (42), and motor (43) from
compressor/motor mounting bracket.
(8)
If necessary, remove elbow (44), tee (45), adapter (46), and tee (47) from motor (43).
e.
Remove flow divider valve as follows:
CAUTION
Cap/cover all hydraulic openings to prevent entry of dirt and contamination of
hydraulic system.
(1)
Disconnect hose (30, Figure 2-1-8) from tube (55) at front of flow divider valve (52).
(2)
If necessary, remove hydraulic tubes (32 and 33) from elbow (44) and tee (45) at rear of motor (43)
and adapters (53 and 54) at valve (52).
(3)
Remove nuts (48), lockwashers (49) washers (50), capscrews (51), and flow divider valve (52) from
bracket (62).
(4)
If necessary, remove adapters (53 and 54), tube (55), and relief valve (56) from valve (52).
(5)
If necessary, remove nut (57), lockwasher (58), washer (59), capscrew (60), washer (61), and
bracket (62) from compressor/motor mounting bracket.
2-1-46
