TM 5-3810-307-24-1-1
(5)
Install new turn signal/hazard switch (29) on steering column with lockwashers (28) and screws (27).
(6)
Connect electrical leads to turn signal/hazard switch (29), remove tags, and install upper cover (25)
and lower cover (26) on steering column. Ensure covers are secure by snapping slots in covers
onto studs on steering column.
Installation
a.
Insert tilt steering column (17, Figure 2-1-9) through cab weldment (18) and secure to weldment with
capscrews (16), lockwashers (15), washers (14), and nuts (13).
NOTE
Prior to sliding splines of steering shaft onto tilt steering column, position
steering wheel so spokes are horizontal.
b.
Slide splines of steering shaft (12) onto tilt steering column (17) and secure with capscrew (11) and nut
(10).
c.
Position clamp (9), filler plate (8), and bracket (7) to cab weldment (18) and dash panel ensuring clamp
ends extend through bracket (7).
d.
Secure bracket (7), filler plate (8) and clamp (9) with washers (3 and 6), lockwashers (2 and 5), nuts (4)
and capscrews (1).
e.
Connect electrical connector for tilt steering column (17).
2-1-65
