TM 5-3810-307-24-1-1
THROTTLE FAST/SLOW CONTROL (SUPERSTRUCTURE CAB)
Removal
a.
Remove screws (1, Figure 2-1-16), washers (2) and clamp (3) securing throttle cable (8) to cab weldment.
b.
Remove clip (10) and pin (11). Then loosen nut (4) and remove clevis (12) from cable (8).
c.
Remove nut (5), washer (6), lockwasher (7), and throttle cable (8) from dash panel.
d.
Remove clip (14) and pin (13). Then disconnect cable (15) from bracket (24).
e.
Remove clip (16), pin (17), and roller (18) from clevis (20).
f.
If necessary, loosen nut (19) and remove clevis (20) and nut (19) from stud in cab floor.
g.
If necessary, remove nuts (21), lockwashers (22), screws (23), and bracket (24) from air throttle pedal.
Repair
Replace all worn, damaged, defective parts.
Installation
a.
If removed, install bracket (24, Figure 2-1-16) on air throttle pedal with screws (23), lockwashers (22), and
nuts (21).
b.
If removed, install nut (19) and clevis (20) on stud in cab floor. Do not tighten nut (19) at this time.
c.
Attach cable (15) to bracket (24) with pin (13) and clip (14).
d.
Install throttle cable (8) in dash panel with lockwasher (7), washer (6), nut (5), and nut (9). Then install nut
(4) and clevis (12) on end of throttle cable (8).
e.
Route cable (15) through clevis (20), and install roller (18) in clevis (20) with pin (17) and clip (16).
f.
Attach clevis (12) to cable (15) with pin (11) and clip (10).
Adjustment
a.
Ensure knob of throttle cable (8, Figure 2-1-16) is pushed all the way in until all slack is out of cables
without moving throttle pedal. If necessary, remove clip (10) and pin (11) and reposition clevis (12). Then install
pin (11) and clip (10) and recheck throttle cable travel. Tighten nut (4).
b.
Ensure clevis (20) is positioned so cable (15) runs smoothly on roller (18) when knob is moved in and out,
then tighten nut (19).
c.
Secure throttle cable (8) to cab weldment with clamp (3), washers (2), and screws (1).
2-1-81
