TM 5-3810-307-24-1-1
Installation
a.
If removed, apply LOCTITE 272 to threads of chain assembly (23, Figure 2-1-17), and install chain
assembly (23) in swing lock pin (24).
b.
If removed, install clevis (6) on chain assembly (23) with pin (22) and clip (21).
c.
If removed, install guide (20) in top of boot (18) with clamp (19), and secure boot (18) to cab floor with
clamp (17).
d.
Install bracket (16) on swing lock control (13) with screws (15) and nuts (14).
e.
Insert cable (5) through dash panel and route cable through boot (18) so cable extends through floor of
cab.
f.
Secure swing lock control (13) with bracket (16) to dash panel with collars (9), screws (8), washer (12),
lockwasher (11), and nut (10).
NOTE
If mounting hardware for shift control was removed, secure shift control to dash
panel, refer to Shift Control Assembly (Superstructure Cab) Installation
procedures.
g.
Install nut (7) and clevis (6) with chain assembly (23) and swing lock pin (24) on cable (5). Screw clevis
(6) onto cable (5) until approximately 1/2 in. of cable threads extend through clevis, then tighten nut (7) onto
clevis (6).
h.
Place handle of swing lock control (13) in the UNLOCKED position, and install clamp (4) over cable (5)
and onto side wall of cab with mounting plate (3), lockwashers (2), and capscrews (1). Do not tighten capscrews
(1).
i.
Pull up on cable (5) until swing lock pin (24) bottoms out in the up position, and tighten capscrews (1).
j.
Install cable (15, Figure 2-1-16) with pin (13) and clip (14), and roller (18) with pin (17) and clip (16).
k.
Disengage positive swing lock, using positive swing lock handle, start engine and carefully rotate boom
over front of carrier ensuring swing lock pin clears carrier.
l.
Operate swing lock control several time to ensure proper operation and shut down engine.
2-1-85
