TM 5-3810-307-24-1-1
l.
Disconnect hydraulic pump disconnect cable from lever at top front left side of transmission.
m.
Disconnect cold start tube (5, Figure 2-2-6) from atomizer (13).
n.
Remove carrier cab air conditioner compressor, refer to Air Conditioner (Carrier Cab) Removal procedures,
steps c. (4) thru (6).
o.
Tag and disconnect heater supply hose from rear of engine cylinder head and heater return line from right
side of engine.
p.
Tag and disconnect fuel line to fuel filter/water separator from fuel heater at right engine well wall.
q.
Tag and disconnect fuel return line from fuel injection pump.
r.
Tag and disconnect air line from rear of throttle air cylinder, refer to Throttle Air Cylinder and Throttle
Linkage Removal procedures.
s.
Tag and disconnect hydraulic hoses for main hydraulic pump from tubes below pump.
t.
Tag and disconnect transmission oil lines to lockup modulator valve from bottom of transmission sump and
right side of transmission just forward of dipstick.
u.
Tag and disconnect two transmission oil lines to lockup solenoid valve (right side transmission well wall)
from right side of torque converter and two oil lines from solenoid valve.
v.
Tag and disconnect hydraulic hoses from steering pump.
w.
Remove emergency steering pump from transmission and allow to hang from oil lines, refer to Emergency
(Standby) Steering Valve and Pump Removal procedures, step c. (3).
x.
Tag and disconnect transmission and engine oil hoses from oil filters under battery box.
y.
Tag and disconnect electrical cables to batteries and battery disconnect switch from alternator and starter
motor.
z.
Tag and disconnect engine ground cable from carrier frame at right side engine well wall.
aa.
Tag and disconnect air line to air dryer from air compressor.
bb.
Tag and disconnect air line to air compressor unloader valve from air governor.
cc.
Tag and disconnect hydraulic hoses to main hydraulic pump from hydraulic tank.
dd.
Tag and disconnect oil hoses to transmission oil cooler from front left side of transmission.
ee.
Tag and disconnect electrical connector for cold start valve (9, Figure 2-2-6).
ff.
Tag and disconnect electrical leads from lockup switch and ground wire from lockup solenoid valve at right
transmission well wall.
gg. Tag and disconnect electrical connector to lockup modulator valve from engine/transmission wiring harness
(rear of transmission).
2-2-6
