TM 5-3810-307-24-1-1
k.
Connect electrical connector to engine/transmission wiring harness for lockup modulator valve and remove
tag.
l.
Connect electrical leads to lockup switch and ground wire to lockup solenoid valve at right transmission well
wall. Remove tags.
m.
Connect electrical connector for cold start valve (9, Figure 2-2-6) and remove tag.
n.
Connect oil hoses from transmission oil cooler to front left side of transmission and remove tags.
o.
Connect hydraulic hoses from main hydraulic pump to hydraulic tank and remove tags.
p.
Connect air line from air compressor unloader valve to air governor and remove tag.
q.
Connect air line from air dryer to air compressor and remove tag.
r.
Connect engine ground cable to carrier frame at right side engine well wall and remove tag.
s.
Connect electrical leads from batteries and battery disconnect switch to starter and alternator. Remove
tags.
t.
Connect engine and transmission oil hoses to oil filters under battery box and remove tags.
u.
Install emergency steering pump on transmission, refer to Emergency (Standby) Steering Valve and Pump
Installation procedures.
v.
Connect hydraulic hoses to steering pump and remove tags.
w.
Connect two oil lines from lockup solenoid valve to right side of transmission and remove tags.
x.
Connect two oil lines to lockup solenoid valve and remove tags.
y.
Connect oil lines from lockup modulator valve to bottom of transmission sump and to right side of
transmission just forward of dipstick.
z.
Connect hoses for main hydraulic pump to tubes below pump and remove tags.
aa.
Connect air line to rear of throttle air cylinder and remove tag.
bb.
Connect fuel return line to fuel injection pump and remove tag.
cc.
Connect fuel filter/water separator inlet fuel line to fuel heater and remove tag.
dd. Connect heater supply hose to rear of engine cylinder head and heater return hose to right side of engine
and remove tags.
ee. Install carrier cab air conditioner compressor on engine bracket, refer to Air Conditioner (Carrier Cab)
Installation procedures.
ff.
Connect cold start tube (5, Figure 2-2-6) to atomizer (13).
gg.
Connect main hydraulic pump disconnect cable to lever at top front left side of transmission.
hh.
Connect throttle cable (49, Figure 2-2-3) to bracket (57) and to air compressor with clamp (40).
2-2-10
