TM 5-3810-307-24-1-1
LEGEND for Figure 2-2-3
1. Nut
19. Washer
38. Nut
2. Lockwasher
20. Idle switch
39. Adjusting bar
3. Capscrew
21. Nut
40. Capscrew
4. Throttle rod
22. Washer
41. Lockwasher
5. Spring
23. Eye bolt
42. Washer
6. Nut
24. Fitting
43. Bracket
7. Lockwasher
25. Cotter pin
44. Bracket
8. Capscrew
26. Washer
45. Capscrew
9. Washer
27. Lever
46. Washer
10. Oil press. sender and
28. Bracket
47. Nut
switch bracket
29. Nut
48. Clamp
assembly
30. Carriage bolt
49. Throttle cable
11. Nut
31. Nut
50. Capscrew
12. Lockwasher
32. Lockwasher
51. Washer
13. Washer
33. Screw
52. Bracket
14. Capscrew
34. Washer
53. Spacer
15. Throttle air cylinder
35. Throttle position
54. Spacer
16. Screw
switch
55. Washer
17. Bracket
36. Capscrew
56. Nut
18. Nut
37. Washer
57. Bracket
r.
Remove capscrew (45), washer (46), and throttle cable (49) from bracket (57).
s.
Remove nuts (47), clamp (48), and throttle cable (49) from bracket on air compressor.
t.
Remove capscrews (50), washers (51), bracket (52), spacers (53 and 54), washer (55), throttle rod (4), nut
(56), and bracket (57) from fuel injection pump lever.
Installation
a.
Install washer (51, Figure 2-2-3) on upper capscrew (50) and insert through upper hole in bracket (52).
b.
Install bushing (54), washer (55), throttle rod (4), and nut (56) on upper capscrew (50). Tighten nut (56)
until assembled parts are secured tightly together.
c.
Position bracket (52) on bracket (57) with upper capscrew (50) through upper hole of bracket (57).
d.
Install bracket (57) on fuel injection pump lever with assembled hardware in upper hole and lower capscrew
(50), washer (51), and spacer (53) in lower hole.
e.
Connect throttle cable (49) to bracket (57) with capscrew (45) and washer (46).
f.
Ensure throttle cable (49) is fully extended and fuel injection pump lever is in its most rearward position,
then secure throttle cable (49) to bracket on air compressor with clamp (48) and nuts (47) ensuring there is no
slack in cable.
g.
If removed, install bracket (43) on bracket (44) with capscrews (40), lockwashers (41), and washers (42).
Do not fully tighten capscrews (40).
h.
If removed, install adjusting bar (39) on bracket (43) with capscrew (36), washers (37), and nuts (38). Do
not fully tighten nuts (38).
2-2-17
