TM 5-3810-307-24-1-1
ENGINE HOOD
Removal
a.
Remove front cowl as follows:
(1)
Remove capscrews (1, Figure 2-2-2), washers (2) and grill (3) from front cowl (10).
(2)
Remove capscrews (5), lockwashers (4), and washers (6) securing front cowl (10) to bracket on
boom rest.
(3)
Remove nut (7), lockwasher (8), washer (9), and front cowl (10) from crane.
b.
Remove center cowl as follows:
(1)
Remove top engine panel and door assembly (17), refer to step c.
(2)
Remove coolant recovery tank (do not disconnect hoses) from center cowl (13) and set aside, refer to
Radiator and Air Cooler Removal procedures.
(3)
Remove exhaust tube and adapter between turbocharger and flexible exhaust tube, refer to Exhaust
System Removal procedures.
(4)
Remove locknuts (11), washers (12), nylon washers (14), and center cowl (13) from crane.
c.
Remove engine top panel and door assembly as follows:
(1)
Remove clips (15), pins (16), and top panel and door assembly (17) from crane.
(2)
If necessary, remove doors from top panel, and handles, latch brackets, and support rods from doors.
d.
Remove rear cowl as follows:
(1)
Remove top engine panel and door assembly (17), refer to step c.
(2)
Remove air intake tubing between air cleaner and turbocharger.
(3)
Remove locknuts (18), washers (19), nylon washers (21), and rear cowl (20) from crane.
(4)
If necessary, remove grill from rear cowl by removing capscrews and washers.
Installation
a.
Install front cowl as follows:
(1)
Position front cowl (10, Figure 2-2-2) on crane and secure left side to stud on boom rest with washer
(9), lockwasher (8), and nut (7).
(2)
Secure right side of front cowl (10) to bracket on boom rest with capscrews (5), lockwashers (4), and
washers (6).
(3)
Apply LOCTITE 242 to threads of capscrews (1), and install grill (3) on front cowl (10) with capscrews
(1) and washers (2).
2-2-12
