TM 5-3810-307-24-1-1
SECTION 16
PREPARATION FOR STORAGE OR SHIPMENT
TABLE OF CONTENTS
Page
INTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
.
.
.
.
.
.
.
.
.
.
2-16-1
PRESERVATION, PACKAGING, PACKING, MARKING, AND SHIPPING REQUIREMENT
.
.
.
.
.
.
.
.
.
.
2-16-1
SHORT TERM STORAGE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
.
.
.
.
.
.
.
.
.
.
2-16-1
LONG TERM STORAGE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
.
.
.
.
.
.
.
.
.
.
2-16-2
PREPARATION FOR SHIPMENT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
.
.
.
.
.
.
.
.
.
.
2-16-2
INTRODUCTION
Before storing the crane for long periods or shipping it to a distant location, certain preparations must be made to
ensure operational readiness when the crane is placed in service again.
PRESERVATION, PACKAGING, PACKING, MARKING, AND SHIPPING REQUIREMENTS
General
These instructions provide minimum preservation and interim storage requirements for the crane. Components
not to be painted will be coated with a preservative, whose application, removal, or use will not damage the
mechanism, structure, or function of the component or end item.
SHORT TERM STORAGE
The crane should be stored in an "operation-ready" status wherein all fluid levels and lubrication points are
maintained in an operational status.
Diesel Engine
Refer to TM 5-3810-307-24-2-2, page 14-23 for short term diesel engine storage instructions.
Fuel Tank
Draining of fuel tanks is not required. If fuel tank is empty, no preservation is required.
Sealing of Openings
Openings that will permit direct entry of water will be sealed with pressure-sensitive tape conforming to PPP-T-60,
Type IV. Large openings will be bridged with waterproof barrier material conforming to PPP-B-1055, and the
edges of the barrier material secured to adjacent surfaces with tape.
Lubricating System
Lubricate the equipment in accordance with the lubrication chart. Check lubricant for level and condition.
Operate the engine until it reaches normal operating temperature to ensure complete lubrication of bearings,
2-16-1 C-1
