TM 5-3810-307-24-1-2
c.
Route the two cables from the coolant heater, through vent opening of rear cowl on
engine compartment hood, into engine compartment, and over transmission. Once on
right hand side of transmission, route at a 90-degree angle toward rear of crane to
circular opening in carrier deck for transmission dipstick. Route downward and to right
over transmission mount. Route battery wiring upward into left hand side of battery box.
Route fuel metering pump wiring along electrical wiring near hydraulic filter and lines
toward fuel metering pump. Use tie wraps to secure cabling in appropriate locations.
CAUTION
Ensure wiring is secured to crane electrical wiring and not to hydraulic
lines and/or the plastic 2mm fuel line.
d.
Cut fuel metering pump wiring (10, Figure J-11) to appropriate length and remove
approximately 1" of outer insulation from the end of the wiring. Remove approximately
3/8" of insulation from the end of each green wire.
e.
Insert wires (10) through rubber grommets (11) with flat end of grommet facing away
from the end of the wire and crimp terminals (12) onto end of each wire.
f.
Insert terminals into plastic connector body (13) with the terminal opening horizontal with
the connector body (13).
NOTE
Specific terminal designations for the fuel metering connector body are
not important.
g.
Push rubber grommets (11) into end of connector body (13) and close end tab of
connector body (13).
h.
Put dielectric grease on connector terminals and connect to fuel metering pump (1)
connector.
i.
Remove hex nut (1, Figure J-15) from positive battery cable terminal on front right hand
battery and hex nut (2) from negative battery cable terminal on rear right hand battery.
NOTE
Remove the hex nut from the portion that secures the cabling to the
battery cable terminal and not the hex nut that tightens the battery cable
terminal to the terminal posts on the battery.
j.
Remove outer insulation from battery wiring cable to separate red and brown wires (3
and 4).
k.
Route red wire (3) towards front of battery box and route brown wire (4) towards rear of
battery box and the negative battery cable terminal. Use tie wraps to secure wires in the
appropriate locations.
l.
Connect spade terminal of 15A in-line fuse holder (5) to positive battery cable terminal
and secure with hex nut (1).
Change-1 J-27
