TM 5-3810-307-24-2-1
NOTE
If the mounting flange O-ring has a colored
stripe, it can not be reused. Replace with a
new O-ring. Furthermore, do not lubricate the
new type O-ring. Instead, lubricate the seating
area of the gear housing.
Lubricate the mounting flange of the fuel injection
pump with clean engine oil.
CAUTION
The fuel pump drive gear inside diameter and
the shaft outside diameter must be clean and
dry before installing the shaft into the gear. A
non-petroleum based cleaner should be used
to clean the drive gear and shaft mounting
surfaces. Failure to do so will result in gear
slippage in the retarded direction.
NOTE
The P7100 fuel injection pump driveshaft has
a provision for a Woodruff key, however, it is
not required. Timing mark alignment is not
required for the P7100 drive gear.
A-41 C-1
