TM 5-3810-307-24-2-2
After rinsing with clean solvent, use compressed air to
dry the block.
Cylinder Block - Inspection (1-01)
Inspect the cylinder bores for glazing.
A surface without glaze will have a crosshatched
appearance with the lines at 25 to 30 degree angles
with the top of the cylinder block.
If de-glazing is required, refer to procedure number(1-
05).
Inspect the cylinder bores for damage or excessive
wear.
Measure the cylinder bores.
Diameter
mm
in
102.000
MIN
[4.0161]
102.116
MAX
[4.0203]
Out-of-Roundness: .038 mm [.0015 in]
0.076 mm [.003 in]
Taper:
Oversize pistons and rings (0.5 mm and 1.0 m
oversize) are available for re-bored cylinder blocks.
Measure the cylinder block overall flatness:
End-to-End
0.076 mm [0.003 in.]
Side-to-Side
0.051 mm [0.002 in.]
Visually inspect for any localized dips or imperfections.
If present, the cylinder head deck must be reground.