TM 10-3950-672-24-2
Low Pressure Fuel Line - Replacement 14mm and
17mm
Remove the line from the lift pump and filter head.
Clean fuel lines with approved solvent. Then blow dry
with clean low pressure air.
Inspect fuel lines for cracks and worn seals.
Inspect and replace any damaged seals.
NOTE
Coat seals in clean engine oil to aid
in installation.
Caution: When replacing fuel lines, replace banjo
fitting sealing washers (1) and ferrules (2) each time
they are removed.
Install the line and tighten the fittings securely.
10mm
Bleed the line by opening the banjo bleed screw.
10mm
Operate the hand lever until the fuel flowing from the
fitting is free of air.
Tighten the bleed screw.
5-87