TM 10-3950-672-24-2
Caution: Do not allow the engine speed to exceed
1,000 RPM before run-in. The internal components
can be damaged.
Caution: Do not shut off the engine Immediately
after the last stop of the run-in is completed. Allow
the engine to cool by operating at low idle for a
minimum of 3 minutes to avoid Internal component
damage.
Engine Run-In Procedure "In Chassis"
(Off-
Highway Vehicles)
Caution: Refer to General Engine Test Procedures
(Chassis Dynamometer) (1 4-05) before operating
the engine to avoid internal component damage.
Operate the engine as follows during the first 3 hours
after rebuild:
5-336