Key to figure 3-14,
d. Reassembly and Installation.
(1) Immerse all parts in clean hydraulic oil for
1 Hose assy
16 Packing
lubrication before reassembly.
2 Elbow (2)
17 Cup
(2) Reassemble steering cylinder as shown in
3 Cylinder assy
18 Piston
figure 3-14.
4 Clamp (2)
19 Cup
e. Installation.
5 Nut (2)
20 Packing
(1) Install steering cylinder (TM 10-3950-'
6 Washer (2)
21 Plate
203-20).
7 Bolt (2)
22 Shaft
(2) Start engine and operate cylinder thru
8 Clamp (2)
23 Nut (4)
several cycles to check for proper operation.
9 Nut (4)
24 Washer (4)
10 Washer (4)
25 Nut
3-19. Steering Gear and Related Parts
11 End
26 Packing
12 Bolt (4)
27 End
a. Removal.
13 Packing (2)
28 Packing
(1) Remove horn button (6, fig. 3-15) and
14 Nut
29 Barrel
unscrew nut (7) from shaft (25). Remove wheel (8).
15 Plate
(2) Remove screws (3) and washers that secure
assembly to bracket.
c. Cleaning and Inspection.
(3) Disconnect and tag hydraulic lines and
(1) Clean all parts.
fittings for proper reassembly. Remove steering
(2) Inspect all parts for corrosion, cracks
assembly from bracket.
distortion, or other defects. Check contact areas foi
b. Disassembly. Refer to figure 3-15 to disassemble
scoring. Remove burs with a fine stone.
steering gear and related parts.
(3) Replace all seals, packings, and un
serviceable parts.
3-25
