c. Cleaning and Inspection.
reassemble steering gear and related parts.
(1) Clean all parts.
e. Installation. Reverse removal procedure in a
(2) Inspect for obvious damage and
above. Start engine and operate steering thru several
defects. Replace defective parts as necessary.
cycles to check for proper steering control.
d. Reassembly. Refer to figure 3-15 to
Section VIII. AXLES BRAKES, AND DIFFERENTIAL
(2) Remove steering cylinder (TM 10-3950- 203-
3-20. Rear Axle Spindles and Related Parts
20).
(3) Refer to figure 3-16 to remove rear axle
a. Removal.
spindles and related parts as shown.
(1) Remove rear wheels (TM 10-3950 20).
1Plug
15 Arm
2 Ring
16 Cotter pin (2)
3 Bearing
17 Nut 12)
4 Plug
18 Washer (2)
5 Ring
19 Pin (2)
6 Bearing
20 Sleeve (2)
7 Pin
21 Fitting (2)
8 Kingpin
22 Cotter pin
9 Cotter pin (6)
23 Nut
10 Nut (6)
24 Washer
11 Washer (6)
25 Fitting
12 Screw
26 Arm
13 Arm
27 Spindle
14 Arm
Figure 3-16. Rear axle spindle and related parts, exploded view
3-27
